- ページ 3

アクセサリー Garde 181KS3STGのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Garde 181KS3STG 3 ページ。 3 stage electric knife sharpener

Operation

*Important note, serrated knives are not recommended to be sharpened using Stage 1 or 2 on this appliance, as the sharpening

discs may damage the blade. Refer to the Operation – Sharpening Serrated Knives for proper sharpening procedure.

1. Place the appliance on a table or sturdy surface.

2. Start the appliance by turning the ON/OFF switch to the "On" position.

NOTE: Be sure to operate the appliance from the front such that you are facing the side labeled with the stages.

3. Place the end of the knife in either one of the blade modules of the first stage, labeled "Coarse". Slowly pull the

blade down and through the Stage 1 blade guides. Then place your blade on the opposite side of the Stage 1

blade module and slowly pull the blade down and through.

Note: Blade strokes should take between 3-5 seconds for a standard 5" blade.

Note: Avoid excessive downward pressure on the sharpening discs. Only mild pressure is needed for knife to

contact sharpening discs.

4. Alternate sides in Stage 1 until you have completed 2-3 pairs of alternating pulls, or until you can feel a burr present.

5. Place the end of the knife in either one of the blade modules in the second stage, labeled "Fine". Slowly pull the

blade down and through the Stage 2 blade guides. Then place your blade on the opposite side of the Stage 2

blade module and slowly pull down and through.

6. Alternate sides in Stage 2 until you have completed 2-3 pairs of alternating pulls.

7. Place the end of the knife in either one of the blade modules in the third stage, labeled "Polish". Slowly pull the

blade down and through the Stage 3 blade guides. Then place your blade on the opposite side of the Stage 3

blade module and slowly pull down and through.

8. Alternate sides in Stage 3 until you have completed 3-4 pairs of alternating pulls, or until you can no longer feel

the burr present.

9. Test the sharpness of the knife by slicing a ripe tomato or piece of paper.

10. If the knife is not sharpened to your satisfaction, repeat steps 7-8.

Operation – Sharpening Serrated Knives

Place the end of the serrated knife in either one of the blade modules in the third stage, labeled "Polish".

Slowly pull the blade down and through the Stage 3 blade guides. Then place your blade on the opposite side

of the Stage 3 blade module and slowly pull down and through.

Alternate sides in Stage 3 until you have completed 3-4 pairs of alternating pulls.

Repeat steps 1-2 as necessary to achieve desired sharpness.

Resharpening

Straight Knives can be resharpened 3-5 times using Stage 3 before knives will need to be sharpened in

Stage 1 and/or Stage 2.

NOTE: Resharpening straight knives beginning at Stage 1 may only be necessary for severely worn or dull blades.

For resharpening beginning in stage 3, refer to steps 1-2 and 7-8 under "Operation".

For resharpening beginning in stage 2, refer to steps 1-2 and 5-8 under "Operation".

Cleaning and Maintenance

Refrain from using water or harsh detergents when cleaning your knife sharpener. To remove any debris from the exte-

rior, a damp cloth with mild detergent such as dish soap is recommended. As needed, the swarf collection compartment

can be emptied to remove any metal dust that has accumulated.