- ページ 10

冷蔵庫 Avanti VFR14PS-ISのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Avanti VFR14PS-IS 20 ページ。

Setting the Temperature Control
• Your unit is designed to be used either as a freezer or a
refrigerator. You can adjust the temperature control to select the
refrigerator or freezer function according to the purpose of use.
• To use as a refrigerator, you may set temperature accordingly by
turning the dial clockwise from the "OFF" position. The
temperature control is marked "FRIDGE" with a scale showing
minimum cooling to the maximum cooling position.
• To use as a freezer, turn the temperature control clockwise to the
position marked "MAX" in area marked "FREEZER", after 24 hours, adjust the control knob the
position that best suits your needs.
NOTE:
Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off
the power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Defrosting Your Unit
Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set
the thermostat dial to "OFF" position.
Remove frozen or perishable foods from the chiller compartment and place it in a cooler to
protect the food.
During the defrost cycle, the ice will melt, place a plate or other type of container below the
evaporator to collect the water.
To remove the water, remove the collection container under the evaporator. Use a sponge or
towel to pick up the melting ice off the unit floor.
Dry the water collection container and place back under the chiller compartment. Defrosting
usually takes a few hours. After defrosting, return the thermostat dial to the desired position. To
defrost quickly remove all foods from the unit and leave the door open. Never use a knife or other
metal instrument to scrape ice/frost from the evaporator.
CAUTION:
Do not use boiling water because it may damage the plastic parts. In addition, never use a
sharp or metallic instrument to remove frost as it may damage the cooling system and will
void the warranty. We recommend using a plastic scraper.
OPERATING YOUR UNIT

CARE AND MAINTENANCE

10