- ページ 9

ワインクーラー Avanti WCR683DZD-2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Avanti WCR683DZD-2 20 ページ。 Dual zone wine chiller

Avanti WCR683DZD-2 取扱説明書
 INSTALLING STAINLESS STEEL HANDLE
This wine chiller includes a stainless steel handle that is not required to operate this unit. To install the
handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Illustration # 1. The gasket is easily displaced by hand, no tools are
necessary.
2. Using a Flat head screwdriver remove the two (2) pre-installed decorative plugs from the
backside of the door as shown below in Illustration #1. Save the decorative plugs for future
use.
3. Insert the two (2) Phillips head handle screws with the lock washers and flat washers
attached through the gasket side of the door frame until the screws pass through the door
frame. Follow the sequence shown below in Illustration # 2.
4. Align the handle with the screws installed in the above step # 3. Tighten the screws using a
Phillips head screwdriver until the handle sets both flush and secured tightly against the door
frame. (DO NOT overtighten as this will cause damage to the handle assembly).
5. Replace the door gasket to its original position.
① G asket
④ Lock W asher
It is recommended you install the Wine Chiller in a place where the ambient temperature is between
72-78 degrees Fahrenheit. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in extreme
cold or hot conditions may cause interior temperatures to fluctuate. The range of 40-65 degrees
Fahrenheit may not be reached.
Recommended Temperatures for Chilling
Red Wines
15º - 18º C
Dry/White Wines
9º - 14º C
Rose Wines
10º - 11º C
Sparkling Wines
② Decorative Screw
⑤ Flat W asher

OPERATING YOUR WINE CHILLER

Wine.
58 – 65º F
48 – 57º F
49 – 51º F
5º - 8º C
40 – 47º F
③ Phillips Head Screw
S/S Handle
9