- ページ 4

配管製品 Brizo ASME A112.18.1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Brizo ASME A112.18.1 20 ページ。 Multichoice valve trim

ページを印刷する

60 Series Installation

Showerhead and Tub Spout Installation

NOTE: It is suggested that you anchor your shower arm and tub spout

elbows or water lines.

RP62605s

(3) = 3/8" - 1/2" (9.5 mm - 12.7 mm)

FOR TUB SPOUT INSTALLATION:

Install 1/2" (13 mm) threaded pipe nipple (1) to

extend past finished wall (2) per dimension (3).

Connection of deck mount spouts to in–wall

valves is not recommended. Neither is the use

of hand showers connected to tub spouts in a

tub/shower push button diverter combination, or

hand showers connected in lieu of a tub spout

to a tub / shower valve.

Piping between valve body and tub spout must

be a minimum of 1/2" (13 mm) copper pipe

or 1/2" (13 mm) iron pipe in a straight drop

no less than 8" (203 mm) but no more than

18" (457 mm) long with only one iron pipe or

copper 90 degree elbow to the tub spout nipple.

VIRAGE

ARM INSTALLATION:

pipe nipple to extend beyond the finished wall

3/8" to 1/2". Apply plumber tape to thread on pipe

nipple and screw brass adapter (1) securely onto

nipple. Apply plumber tape to outlet end of

shower arm and screw showerhead (2) onto the

shower arm (3), using provided wrench (4) to

tighten securely. Check position of set screw on

top of shower arm (3) making sure it is not

sticking through to the inside opening where it

could interfere with the assembly. Slide shower

arm and head assembly over the adapter and

tighten set screw against the adapter.

Install a 1/2" threaded pipe nipple to extend

beyond the finished wall 3/8" to 1/2". Apply

plumber tape to thread on pipe nipple and screw

brass adapter (1) securely onto nipple. Check

position of set screw on bottom of spout (2)

making sure it is not sticking through to the

inside opening where it could interfere with the

assembly. Slide tub spout over the adapter and

tighten set screw, on bottom of spout, against

the adapter. Note: This spout utilizes a pull

down diverter mechanism. To divert from

spout to shower, pull down on spout tip (3).

SHOWERHEAD AND SHOWER

Install a 1/2" threaded