- ページ 7

電動工具 Makita DCO140のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita DCO140 13 ページ。 Cordless cut-out tool
Makita DCO140 にも：取扱説明書 (13 ページ), 技術情報 (8 ページ)

ページを印刷する

Overheat protection

This protection works when the tool or battery is over-

heated. In this situation, let the tool and battery cool

before turning the tool on again.

Overdischarge protection

This protection works when the remaining battery

capacity gets low. In this situation, remove the battery

from the tool and charge the battery.

Adjusting depth of cut

► 1. Thumb screw 2. Shoe

To adjust the shoe, loosen the thumb screw. Slide the

shoe to the desired position and then tighten the thumb

screw securely. Check for the proper clearance beneath

the workpiece before cutting not to strike a hard surface

such as the floor, workbench, etc.

Switch action

CAUTION:

•

Before installing the battery cartridge into the

tool, always check to see that the slide switch

actuates properly and returns to the "OFF"

position when the rear of the slide switch is

depressed.

► 1. Slide switch

To start the tool, slide the slide switch toward the "I

(ON)" position. For continuous operation, press the

front of the slide switch to lock it.

To stop the tool, press the rear of the slide switch, then

slide it toward the "O (OFF)" position.

7 ENGLISH

Accidental re-start preventive

function

Even if the battery cartridge is installed on the tool with

the slide switch in the "I (ON)" position, the tool does

not start.

To start the tool, first slide the slide switch toward the

"O (OFF)" position and then slide it toward the "I (ON)"

position.

ASSEMBLY

CAUTION:

•

Always be sure that the tool is switched off and

the battery cartridge is removed before adjust-

ing or checking function on the tool.

Installing or removing bit

CAUTION:

•

Do not tighten the collet nut without installing a

bit, or the collet cone may break.

► 1. Collet nut 2. Shoe 3. Shaft lock 4. Tighten

5. Loosen

Press the shaft lock to prevent shaft rotation when

installing or removing the bit.

To install the bit, place it in the collet cone as far as it

goes and then tighten the collet nut securely with the

shoe as a wrench.

To remove the bit, follow the installation procedure in

reverse.

Changing the collet cone (country

specific)

CAUTION:

•

Use the correct size collet cone for the bit which

you intended to use.

•

Do not tighten the collet nut without installing a

bit, or the collet cone may break.