- ページ 4

エアクリーナー Airfree WM 140のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Airfree WM 140 8 ページ。
Airfree WM 140 にも：取扱説明書 (12 ページ)

Drill 3 holes spaced apart, following the attached diagram*. After drilling the 3 holes,

install the enclosed 2 top screws leaving a 2mm free distance from the wall. Hang

Airfree

from the 2 top screws. In sequence, install firmly the third screw over the

Airfree

bottom screw holder to prevent Airfree

not be removed after installation by exercising upward pressure.* The single bottom

hole is to be preferably drilled at 15 cm from the floor level just for the WM 140 series.

Plug the power cord into the nearest outlet. Make sure the surface is dry (never place

Airfree

on wet floor or immerge it in water). Make sure the On/Off led is on. After 30

minutes the top lid should be warm.*

Check if the area is compatible with the unit capacity to achieve best unit performance.

Using Airfree

in rooms larger than its capacity will greatly reduce its purifying

capacity.

Airfree

must be continuously on in the same room, 24 hours a day. Nevertheless,

temporarily removing it from the room will allow new microorganism contamination to

grow but it will be destroyed when Airfree

without Airfree

the higher the new contamination in the room.

Airfree

is to be used preferably in rooms larger than 4 m² or 10 m³.

Rooms with air condition or ventilation will not affect the air sterilisation efficiency of

your Airfree

. Same for Heating systems.

Airfree

can be placed in corridors but the air sterilisation effects will barely have any

effect in connecting rooms.

Avoid place the unit near open doors or windows to prevent some of the sterilised air

to exit the room.

Installing and Connecting

from moving. Make sure Airfree can

is plugged in again. The longer the period