- ページ 8

ウォーター・ディスペンサー Avanti WD001のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Avanti WD001 12 ページ。 Hot and cold water dispenser

Steps To Replace Water Bottles

Remove cap from the 5-gallon bottle and use a clean cloth to wipe off the neck of the bottle.



Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on



opening of bottle while placing in reservoir.

Place the 5-gallon bottle of water on the water intake, allow the water to stand for approximately 5



minutes.

Wipe off any water which may have splashed on dispenser top.



When a new bottle is installed you must open the hot water faucet and remove no less than 4 full cups of

water to insure the water flows properly and the water reservoir is at the proper level.

For operation of unit, please fill water and make sure water settles inside the water tank, and then

switch on both hot and cold switches at back of unit.

NOTE:

THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.

NOTE:

THE DISPENSING CAPACITY OF HOT WATER IS APPROXIMATELY 2 ½ CUPS AT A SINGLE

TIME. ONCE THE MAXIMUM NUMBER OF CUPS HAS BEEN DISPENSED THE RESERVOIR

WILL REFILL AND BE READY TO DISPENSE ANOTHER 2 ½ CUPS IN APPROXIMATELY 5 – 6

MINUTES

OPERATING YOUR WATER DISPENSER

To get hot water:

 Slide red safety button to the right and hold

while pressing downward on hot water faucet

to dispense hot water.

 Safety button will return to its original position

when faucet is released.