- ページ 6
DVR HIKVISION HiLook SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION HiLook Series 17 ページ。 Smart hybrid light bullet & turret camera
HIKVISION HiLook Series にも： クイック・スタート・マニュアル (18 ページ), ユーザーマニュアル (18 ページ), ユーザーマニュアル (14 ページ), ユーザーマニュアル (20 ページ), ユーザーマニュアル (18 ページ), ユーザーマニュアル (13 ページ)
ページを印刷する
Warnings Follow
these safeguards to
prevent serious injury
or death.
Warnings
In the use of the product, you must be in strict
compliance with the electrical safety regulations of the
nation and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950-1 and IEC62368-1
standard. Refer to technical specifications for detailed
information.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
An all-pole mains switch shall be incorporated in the
electrical installation of the building.
Do not connect multiple devices to one power adapter
to avoid over-heating or a fire hazard caused by
overload.
Make sure that the plug is firmly connected to the
power socket.
If smoke, odor or noise rise from the device, turn off
the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cautions
No naked flame sources, such as lighted candles, should
be placed on the equipment.
Install the equipment according to the instructions in
this manual.
To prevent injury, this equipment must be securely
attached to the floor/wall in accordance with the
installation instructions.
Do not drop the camera or subject it to physical shock.
Do not touch senor modules with fingers.
Do not place the camera in extremely hot, cold (the
operating temperature shall be -40°C to 60°C), dusty or
damp locations, and do not expose it to high
electromagnetic radiation.
If cleaning is necessary, use clean cloth with a bit of
ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright places.
The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnetic
radiation or extremely hot, cold, dusty or damp
environment.
To avoid heat accumulation, good ventilation is
required for the operating environment.
Cautions Follow these
precautions to prevent
potential injury or
material damage.