- ページ 6
DVR HIKVISION HiWatch SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION HiWatch Series 15 ページ。 Hd turret and bullet camera
HIKVISION HiWatch Series にも： クイック・スタート・マニュアル (15 ページ), クイック・スタート・マニュアル (20 ページ), クイック・スタート・マニュアル (18 ページ), ハウツー (4 ページ), ユーザーマニュアル (15 ページ)
ページを印刷する
2 Installation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1 Installation of Type I Camera
Before you start:
Both wall mounting and ceiling mounting are suitable
for the camera. We take ceiling mounting as an example
in this section. You can take the steps of ceiling
mounting as a reference, when adopting wall mounting.
Steps:
1. Disassemble the turret camera by rotating the trim
ring anticlockwise to get the trim ring out of the
camera as shown in the figure below.
2. Paste the drill template (supplied) to the place
where you want to install the camera.
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3. Attach the camera to the ceiling, and secure them
with supplied screws.
Figure 2-1 Get the Trim Ring out
Figure 2-2 Drill Template