- ページ 3

屋外倉庫 GARDEN MASTER GM3023のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。GARDEN MASTER GM3023 8 ページ。 Gable roof shed
GARDEN MASTER GM3023 にも： 組み立て説明書 (2 ページ)

ページを印刷する
GARDEN MASTER GM3023 組立説明書
STEP 1:
BACK WALL
1.
Join 4
sheets together with 2 rivets through the overlapping
A
ribs making sure the ends of the sheets are flush.
2.
Cap sheeting with
F
and bottom. This will finish 10-15mm shorter than the sheet.
3.
Rivet the channels through the end ribs and
every 2nd rib between.
4.
Make sure you put at least 1 rivet
per sheet up through the underside
of the channel into the pan
of the sheet.
CHANNELS WITH CUTOUTS
The cutouts go to the inside of the panel to
allow easy fitment of the end walls
on assembly. Note top and bottom
channels have different cutouts!
TOP
CHANNEL
STEP 2:
ROOF
1.
Join 4
1600mm sheets together, same as the back.
B
2.
Cap sheeting with
G
3.
Rivet the channels at every second rib but not the corners at this stage.
The U channel will finish 10mm shorter than the sheeting.
4.
Place the short flange of
with sheeting and put 1 rivet in the centre to hold the 'L'. Rivet the corners through
the channels and 1 more between the corner and
the centre rivet. Perform the same at the other
end and next roof panel.
5.
Rivet
ridge beam to one roof
K
panel and rivet through
internal flange and
thru the ends
of the ridge
beam into
the 'L'.
channels putting the cutouts top
BOTTOM
CHANNEL
3000mm channels.
'L' on top of the rib at 1 end. Make sure ends are flush
I
I
G
If you need advice, call us
F
K
G
B
FREE
on
0800 807 433
or email us at [email protected]
If you choose to vary from these instructions your warranty will be impaired.

YOU WILL NEED:

4 x 1830mm sheets for the back
A
2 x 3000mm channels
F
GARDEN MASTER TIP
Put extra rivets in for high wind areas,
particularly on the underside.
F
A
YOU WILL NEED:
B
8 x 1200mm sheets
G
4 x 3000mm channels
I
4 x 1200mm 'L's
K
1 x 3025mm ridge beam
Simply grab the wooden
block supplied with your
shed and fold each pan on
the roof panel to 45 degrees
Each pan that will connect
into the ridge cap will need to
be folded up to prevent any
water coming in through the
center of the ridge beam.
I
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
3