- ページ 6

ハンドヘルド Janam XM seriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Janam XM series 13 ページ。 Four-slot cradle kit
Janam XM series にも：クイック・スタート・マニュアル (8 ページ)

ページを印刷する

Installing and Charging the Battery

A. INSTALLING THE BATTERY

1. To access the battery compartment, turn the battery screw counterclockwise to open the latch and

remove battery cover.

2. Position the battery-lift strap, place the Lithium-ion battery and snap into place.

3. Replace the battery cover by positioning the top prongs ﬁ rst and sliding cover into place.

Tighten battery screw by turning clockwise.

B. CHARGING THE BATTERY

Important Note: The main battery charges the backup battery in the XM Series unit. Once the main battery is

fully charged, do not remove it from the unit for 24 hours. During this period the device cannot maintain any

user data if the battery is removed.

To charge the battery using the USB Cable or Serial Cable:

a. Connect the power supply to the USB or Serial cable.

b. Connect snap-on end of USB or Serial cable to bottom of device making sure the word "TOP" on the

connector faces front.

c. Insert appropriate AC plug and plug in the power supply. Use only easily accessible wall outlets that are

easily reached with the length of supplied power cable.

To charge the battery using the Single-Slot or Four-Slot Cradle:

a. Connect the power supply to the cradle.

b. Connect the line cord to the power supply.

c. Insert appropriate AC plug and plug in the power supply. Use only easily accessible wall outlets that are

easily reached with the length of supplied power cable.

d. Place the XM device in cradle. The LED will illuminate to conﬁ rm connection (orange indicates charging,

green indicates fully charged and red indicates fault).

e. The battery is fully charged in approximately 2 hours.

f. Charge a spare battery by placing the battery in the spare battery well with label up and connectors lined up.

Page 5

XM Series Quick Start Guide