- ページ 11

レンジ KitchenAid YKFEG500EBSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid YKFEG500EBS 16 ページ。 Freestanding
KitchenAid YKFEG500EBS にも：クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (18 ページ)

ページを印刷する

1. Cut out and remove part of metal ground strap, as shown.

A. Metal ground strap

B. Discard.

C. Ground-link screw

2. Use a Phillips screwdriver to remove the ground-link screw

from the back of the range. Save the ground-link screw and

the end of the ground link under the screw.

3. Pull the wires through the strain relief on bottom of range.

Allow enough slack to easily attach wiring to the terminal

block.

A. Terminal block

B. Ground-link screw

C. Cord/conduit plate

D. Bare (green) ground wire

E. Line 2 (red) wire

F. Neutral (white) wire

G. Line 1 (black) wire

4. Attach terminal lugs to line 1 (black), neutral (white), and line 2

(red) wires. Loosen (do not remove) the setscrew on the front

of the terminal lug and insert exposed wire end through

bottom of terminal lugs. Securely tighten setscrew to torque

as shown in the following Bare Wire Torque Specifications

chart.

A. Terminal lug

B. Setscrew

C. Line 2 (red) wire

D. Neutral (white) wire

E. Line 1 (black) wire

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

Wire Awg

8 gauge copper

6 gauge aluminum

5. Use a hex driver or Phillips screwdriver to connect the bare

(green) ground wire to the range with the ground-link screw

and ground-link section. The ground wire must be attached

first and must not contact any other terminal.

6. Use ³⁄₈" nut driver to connect the neutral (white) wire to the

center terminal block post with one of the 10–32 hex nuts.

A. 10–32 hex nut

B. Line 2 (red)

C. Bare (green) ground wire

D. Ground-link screw

7. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

8. Securely tighten hex nuts.

9. Replace terminal block access cover.

10. Slide range backs so that the rear range foot is engaged in

the anti-tip bracket slot

Torque

25 lbs-in. (2.8 N-m)

35 lbs-in. (4.0 N-m)

E. Neutral (white) wire

F. Line 1 (black)

G. Terminal lug