- ページ 17

レンジ KitchenAid YKFEG500ESSのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。KitchenAid YKFEG500ESS 18 ページ。 Freestanding
KitchenAid YKFEG500ESS にも：取付説明書 (20 ページ), クイック・スタート・マニュアル (2 ページ)

ページを印刷する

1. Clean Cycle

3. Slowly push the drawer into the range.

A. Engage drawer glide.

NOTE: When properly installed, the rear slides on the bottom

of the drawer will engage the base rails and the drawer will not

tip when items are placed in the drawer.

Oven Door

For normal range use, it is not suggested to remove the oven

door. However, if removal is necessary, make sure the oven is off

and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

1. Open oven door all the way.

2. Pinch the hinge latch between two fingers and pull forward.

Repeat on other side of oven door.

3. Close the oven door as far as it will shut.

4. Lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from

the oven door frame.

To Replace:

1. Insert both hanger arms into the door.

A. Hinge latch

2. Open the oven door.

You should hear a "click" as the door is set into place.

3. Move the hinge levers back to the locked position. Check that

the door is free to open and close. If it is not, repeat the

removal and installation procedures.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check that the range is level. See the "Level Range" section.

5. Use a mild solution of liquid household cleaner and warm

water to remove waxy residue caused by shipping material.

Dry thoroughly with a soft cloth. For more information, read

the "Range Maintenance and Care" section.

6. Read the Quick Start Guide and online Control Guide.

7. Plug power cord into appropriate outlet. Turn power on.

8. Turn on surface burners and oven. See the Quick Start Guide

and online Control Guide for specific instruction on range

operation.

If Range Does Not Operate, Check the Following:

■ Household fuse is intact and tight; or circuit breaker has

not tripped.

■ Range is plugged into a grounded outlet.

■ Electrical supply is connected.

IMPORTANT: If the range control displays an "F9" or "F9,

E0" error code, the electrical outlet in the home may be

miswired. Disconnect power and contact a qualified

electrician to verify the electrical supply.

■ See the online Troubleshooting section.

When the range has been on for 5 minutes, check for heat. If

the range is cold, turn off the range and contact a qualified

electrician.