- ページ 8

照明器具 Jandy CPHVLEDS50のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Jandy CPHVLEDS50 20 ページ。 Watercolors led lights underwater large and small light
Jandy CPHVLEDS50 にも：インストレーション・マニュアル (16 ページ)

ページを印刷する

Page 8

The wet niche must be properly electrically

bonded and grounded via the No. 8 AWG ground

connector located at the rear of the niche. See

Figure 1.

To be certain that the pool's electrical system meets

all applicable requirements, the electrician should also

consult the local building department.

4.2

Replacing the Light Fixture

NOTE Perform these steps only after the electrical

system requirements are met.

WARNING

Failure to bring the pool's electrical system up to

code requirements before installing the underwater

light will create an electrical hazard which could

result in death or serious injury to pool or spa users,

installers, or others due to electrical shock, and may

also cause damage to property.

NOTE The light fixture may be replaced without

removing water from the pool.

Turn off the main electrical switch or circuit

breaker, as well as the switch, which operates the

underwater light.

Unscrew the special pilot screw at top of the face

ring and remove the light assembly from the niche,

and place the assembly on the deck.

WARNING

Be sure to keep the special pilot screw provided

with this underwater light. This screw mounts and

electrically grounds the housing securely to the

mounting ring and wet niche. Failure to use the

screw provided could create an electrical hazard,

which could result in death or serious injury to pool or

spa users, installers or others due to electrical shock.

Remove Junction Box cover, disconnect the light

ﬁ xture wires and strain relief, and then pull the

cord out of the conduit from the niche.

Feed the new light ﬁ xture cord through the conduit

from the niche to the Junction Box.

NOTE Depending on the length of the conduit, special

tools may be required to pull the cord through

the conduit.

Leave at least four (4) feet of cord to coil around

the light ﬁ xture or coiled into the base of the light

niche. See Figure 1. This allows the light to be

serviced after the pool is ﬁ lled with water.

Cut the cord at the Junction Box, leaving at least

six (6) inches of cord to make connections.

Strip six (6) inches of the outer cord jacket from

the cord to expose the three insulated wires. Be

careful not to damage the insulation on the three

(3) inner wires.

Install the strain relief over the cord jacket and

connect all three wires to the corresponding circuit

wires in the junction box. Install the junction box

cover.

Reinstall the light assembly into the niche and

tighten the special pilot screw.

WARNING

Use only the special pilot screw provided with this

underwater light. This screw mounts and electrically

grounds the housing securely to the mounting ring

and wet niche. Failure to use the screw provided

could create an electrical hazard, which could result

in death or serious injury to pool or spa users,

installers or others due to electrical shock.

10. Fill the pool until the underwater light is

completely submerged in water before operating

the light for more than 10 seconds. Turn on main

switch or circuit breaker, as well as the switch,

which operates the underwater light, to check for

proper operation. Refer to Section 6, Operating

Instructions.

WARNING

Never operate this underwater light for more than

10 seconds unless it is totally submerged in water.

Without total submersion, the light assembly will get

extremely hot, which may result in serious burns

or in breakage of the bulb or lens. This may result

in serious injury to pool or spa users, installers, or

bystanders or in damage to property.