ページを印刷するAdjusting the swing-away footrest
(models no. 700 - 425 and 700 - 427)
1. Remove impact guards and/or calf strap, if necessary.
2. Loosen, but do not remove the bolt & locknut that secure the lower
footrest sub-assembly to upper footrest support.
3. Reposition the lower footrest sub-assembly to the desired height.
4. Securely tighten the bolt & locknut.
5. Repeat STEPS 1- 4 for the other footrest, if necessary.
6. Replace impact guards and/or calf strap, if necessary.
7. Reinstall the swing-away footrest assembly.
1 2
Installing the swing-away elevating leg rest
(models no. 700-426 and 700-428)
1. Place the elevating leg rest assembly on the outside of the wheelchair
and install the hinge plates onto the hinge pins on the wheelchair frame.
2. Rotate leg rest assembly toward the inside of the wheelchair until
it locks in place.
3. Repeat STEPS 1-2 for the other leg rest assembly.
NOTE - The footplate will be on the inside of the wheelchair when the leg
rest is locked in place.
4. Once seated in wheelchair, adjust the footrest to correct height by
loosening the locknut and sliding the lower footrest tube up or down
until desired height is achieved.
5. Tighten locknut securely.
6. To release the leg rest, push the leg rest release handle toward the inside
of the wheelchair (facing the front of the wheelchair) and swing the leg rest
assembly to the outside of the wheelchair.
!
WARNING:
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware
is tightened securely otherwise injury or damage may result.
1 3