- ページ 5

プールフィルター Jandy Jandy Pro SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Jandy Jandy Pro Series 12 ページ。 Single element cartridge pool & spa cs filters
Jandy Jandy Pro Series にも：インストレーション・マニュアル (16 ページ), 設置および操作マニュアル (20 ページ), オーナーズマニュアル (20 ページ), マニュアル (8 ページ), クイック・スタート・マニュアル (2 ページ), 設置および操作マニュアル (20 ページ), インストレーション・インストラクション (2 ページ), 設置および操作マニュアル (16 ページ), 設置および操作マニュアル (16 ページ), 設置および操作マニュアル (16 ページ)

Nicheless Underwater LED Lights | Owner's Manual

Verify that the pool meets the requirements of the current National Electri-

cal Code

(Canadian Electrical Code, in Canada)

ordinances. A licensed or certified electrician must install the electrical

system to meet or exceed those requirements before the underwater light

is installed. Some of the requirements of the National Electrical Code,

which the pool electrical systems must meet, are as follows:

The junction box or the low-voltage transformer must be located

at least eight (8) inches (measured from the inside of the bottom of

the junction box or transformer) above the MAXIMUM water level,

OR at least four (4) inches above the ground level or pool deck,

whichever is greater. The junction box or transformer must also be

installed at least forty-eight (48) inches (4 ft.) from the edge of the

pool. See Figure 1.

A standard 1.5" plastic wall / return fitting (not included) must be

installed so that the top edge of the underwater light's lens is at least

4 inches (10.2 cm) below the surface of the water in the pool. See

Figure 1.

NOTE To be certain that the pool's electrical system meets all applicable

requirements, the electrician should also consult the local building

department.

12 VAC Transformer

Rigid

Conduit

Figure 1.

Jandy Pro Series LED Light Installation with standard

1.5" plastic fitting

48"

min.

ENGLISH

and all local codes and

8" min. Junction Box or Low

Voltage Transformer, to the

max water level of the pool.

4" min. to top of Lens.

Page 5