Jandy Pro Series Levolor
II Electronic Water Leveler
®
Models K-2100
Section 4. Operation
4.1
Controller Lights
The controller has five (5) lights. See Figure 10 and
Table 2, LED Indicators.
The Power light turns green when the power is on. The
Sensor light turns yellow when water is not touching the
Fill Sensor probe.
Then the Fill light turns green, indicating that the valve
is operational and filling the fountain (or circulating
water in another application). The Fill light turns red
when the unit enters Safety Lockout Mode.
The Low Water Sensor light turns yellow when the Low
Water Sensor probe is not touching the water. Then the
Low Water Cutoff light turns green, indicating that the
pump is being shut off.
4.2
Fill Safety Lockout Mode
The Levolor is equipped with a Fill Safety Lockout
Mode. This means that if the Fill Sensor probe has
not been touched by water within the pre-set Fill time
period, the Levolor activates the Safety Lockout,
turning the valve off for 24 hours. During Safety
Lockout, the Fill light turns from green to red.
The pre-set factory Fill time is 20 minutes. To change
it, see Section 4.3, Change Fill Time for Safety Lockout
Mode.
Table 2. LED Indicators
LED
Power
Turn Power ON
Sensor
Detect Low Water
Fill Fountain (or Circulate
(Water in Other Application)
Filling
Fill Safety Lockout
Low Water
Detect Very Low Water
Sensor
Low Water
Turn Pump OFF
Cutoff
|
Function
Color
Green
Yellow
Green
Red
Yellow
Green
Installation and Operation Manual
Power
Low Water
Sensor
Figure 10. Controller Lights
Operating
Delay to Turn
Mode
Power is
ON
Water is
Low
Fill Valve is
20 Seconds after
ON
Sensor Turns ON
Fill Valve is
OFF
Water is
Very Low
20 Sec, 1 Minute
Pump is OFF
ENGLISH
Filling
Sensor
Delay to Turn
Function ON
Function OFF
None
None
20 Seconds after
Sensor Turns OFF
20, 40 or 60
24 Hours
Minutes
None
or 5 Minutes
Page 13
Low Water
Cutoff
None
None
None
None