- ページ 4

プールフィルター Jandy Versa-Plumb CL 460のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Jandy Versa-Plumb CL 460 20 ページ。 Cartridge pool filters
Jandy Versa-Plumb CL 460 にも：設置および操作マニュアル (14 ページ), 設置および操作マニュアル (20 ページ)

ページを印刷する

Page 4

Safety Information

Section 1.

Important Safety Warning

1.1

• Do not connect system to an unregulated city water system or other external source of pressurized

water producing pressures greater than 35 PSI.

• Pressurized air in system can cause product failure or also cause the ﬁ lter lid to be blown off which

can result in death, serious personal injury, or property damage. Be sure all air is out of system

before operating or testing the equipment.

MAXIMUM OPERATING PRESSURE OF THE FILTER IS 50 PSI. NEVER SUBJECT THE FILTER

TO ANY OPERATING PRESSURE EXCEEDING 50 PSI.

This filter operates under high pressure. When any part of the circulating system, i.e., filter, pump,

valve(s), clamp, etc. is serviced, air can enter the system and become pressurized when the system

is restarted. Pressurized air can cause product failure or also cause the filter lid to be blown off which

can result in death, serious personal injury or property damage. To avoid this po ten tial haz ard, fol low

all of the in struc tions in this man u al.

To minimize risk of severe injury or death the filter and/or pump should not be subjected to the piping

system pressurization test.

Local codes may require the pool piping system to be subjected to a pressure test. These

requirements are generally not intended to apply to the pool equipment such as filters or pumps.

Jandy pool equipment is pressure tested at the factory.

If however this WARNING cannot be followed and pressure testing of the piping system must include

the filter and/or pump BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:

• Check all clamps, bolts, lids, lock rings and system accessories to ensure they are properly

installed and secured before testing.

• RELEASE ALL AIR in the system before testing.

• Water pressure for test must NOT EXCEED 35 PSI.

• Water temperature for test must NOT EXCEED 100°F (38°C).

• Limit test to 24 hours. After test, visually check system to be sure it is ready for operation.

Notice: These parameters apply to Jandy equipment only. For non-Jandy equipment, consult equipment manufacturer.

1.2 General Safety Instructions

ATTENTION INSTALLER:

This manual contains important information about the installation, operation and safe use of this

product. This information should be given to the owner/operator of this equip ment.

Use equipment only in a pool or spa installation.

Before repositioning valve(s) and before beginning the assembly, disassembly, or adjustment of the clamp, or

any other service of the circulating system; (A) turn the pump off and shut off any automatic controls to ensure

the system is not inadvertently started during servicing; (B) open the air release valve; (C) wait until all pressure

is relieved (air will have stopped ﬂ owing from the air release valve).

Whenever installing the ﬁ lter clamp follow Section 3.5 of this manual, "Clamp Installation".

Once service on the circulation system is complete, follow Section 4 of this manual, "Start-up and Operation".

Maintain circulation system properly. Replace worn or damaged parts immediately.

Be sure that the ﬁ lter is properly mounted and positioned according to these installation instructions.

Do not pressure test above 35 PSI. Pressure testing must be done by a trained pool professional.

Cartridge Pool Filters - CL and CV Series Filters

WARNING

SAVE THESE INSTRUCTIONS