- ページ 4

プールフィルター Jandy Versa-Plumb CL 460のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Jandy Versa-Plumb CL 460 14 ページ。 Cartridge pool filters
Jandy Versa-Plumb CL 460 にも：設置および操作マニュアル (20 ページ), 設置および操作マニュアル (20 ページ)

ページを印刷する

2.1 Introduction

This manual contains information for the proper

installation and operation of the Jandy® CL Series

Cartridge Filters. Procedures in this manual must be

followed exactly. To obtain additional copies of this

manual contact us at 707.776.8200 ext. 237. For

address information see back cover.

2.2 Description

Cartridge filters do not require sand or diatomaceous

earth as the filter medium. Instead, the filter contains

filter elements which are easily removed for cleaning or

replacement.

Dirty water flows into the filter tank through the water

line connected to the lower bulkhead (inlet) on the

bottom half of the tank body. It is directed through the

filter cartridge inside of the filter. The debris is collected

in the filter and the clean water flows out of the filter

through the upper bulkhead (outlet) on the bottom half

of the tank body. Clean water is returned through the

piping system to the pool.

As debris collects in the filter, the pressure will rise and

water flow to the pool will diminish. The filter will

eventually become so plugged with debris that it will

be necessary to remove the filter cartridges and clean

them with soap and water.

Note that a filter removes dirt and other suspended

particles but does not sanitize the pool. Pool water

must be sanitized and chemically balanced for clear

water. The filtration system should be designed to meet

local health codes. At a minimum, the system should

turnover the total volume of water in your pool two to

four times in a 24 hour period.

2.3 General Requirements

1. For best overall performance place the system as

close to the pool as possible.

2. The filter should be located on a level concrete slab

so that the orientation of the valve outlets and the

pressure gauge are convenient and accessible for the

installation and operation of the unit.

3. Protect the filter from the weather.

4. If fitting a chlorinator and/or any other device into

the filtration plumbing circuit, great care must be

exercised to ensure that the appliance is installed in

accordance with the Manufacturer's Instructions and

any standards that may exist.

5. We recommend the use of barrel unions to connect

each component of the water conditioning system to

ease in future servicing. Barell unions are provided with

all Jandy filters.

SECTION 2. General Information

6. The maximum working pressure for this filter is 50

psi. Never subject the filter to pressure exceeding 50

psi, even when conducting hydrostatic pressure tests.

Pressures above 50 psi can cause the lid to be blown

off.

When performing hydrostatic pressure tests or when

testing for external leaks of the completed filtration and

plumbing system, ensure that the maximum pressure

the filtration system is subjected to does not exceed

the maximum working pressure of any of the

components within the system.

2.4 Specifications and Dimensions

1. See Table 1 and Figure 1.

Table 1. Cartridge Filter Specifications

Model No.

Filter

Area (ft2)

Max.

Flow (gpm)

Six Hour

Capacity (gal.)

Max. Working

Pressure (psi)

Normal Start Up

Pressure (psi)

Dimension "A"

Figure 1- Dimensions, Jandy CL Series Cartridge Filters

CL340

CL460

CL 580

340

460

580

127

150

45,720

54,000

6-15

41in.

47in.