IP電話 Avaya 4600 SeriesのPDF 安全上のご注意をオンラインで閲覧またはダウンロードできます。Avaya 4600 Series 11 ページ。 Infrared dialing
Avaya 4600 Series にも：設置および安全に関する指示 (11 ページ), 接続 (14 ページ), 製品情報 (2 ページ), マニュアル (4 ページ)

ページを印刷する

4600 Series IP Telephone

Safety Instructions

For all IP Telephone documentation,

go to http://www.avaya.com/support

IMPORTANT USER SAFETY INSTRUCTIONS

The most careful attention has been devoted to quality standards in the manufacture of

your new telephone. Safety is a major factor in the design of every set. But, safety is

YOUR responsibility too.

Please read carefully the helpful tips listed below and on the next page. These

suggestions will enable you to take full advantage of your new voice terminal. Then,

retain these tips for later use.

WARNING:

All powering over telecommunication wiring must be via UL listed power supplies with

outputs of 42-56 Volts DC,

1.3 Amps DC.

This telephone is NOT for residential use. It is for business systems applications ONLY.

It will NOT operate on public networks. It MUST BE connected to a DEFINITY

Enterprise Communications Server through an ethernet LAN. Use in a residential

environment could result in an electrical short circuit when the telephone wiring is set

up to provide other applications, for example, for appliance control or power

transformers. The optional AC power used in these applications may create a safety

hazard by placing a direct short circuit across the telephone wiring.

WARNING

(4606/4612/4624/4630):

This is a Class A product. In a domestic environment this product may cause radio

interference in which case the user may be required to take adequate measures.

Note: the 4601, 4602, 4602SW, 4610SW, 4620, 4620SW, 4621SW, 4622SW, 4625SW,

4630SW, and 4690 IP Telephones are Class B products and the preceding Warning

does not apply to them.

WARNING:

The ethernet interface should not leave the building premises unless connected to

telecommunications devices providing primary and secondary protection, as

applicable.

Use

When using your telephone equipment, the following safety precautions should always

be followed to reduce the risk of fire, electric shock, and injury to persons.

•

Read and understand all instructions.

•

Follow all warnings and instructions marked on the telephone.

•

This telephone can be hazardous if immersed in water. Do not use this product near

water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet

Comcode: 700361314

555-233-779

Issue 8, March 2005

basement or near a swimming pool. To avoid the possibility of electric shock, do not

use it while you are wet. If you accidentally drop the telephone into water, do not

retrieve it until you have first unplugged the line cord from the modular wall jack.

Then, call service personnel to ask about a replacement.

•

Avoid using the telephone during electrical storms in your immediate area. There is

a risk of electric shock from lightning. Urgent calls should be brief. Even though

protective measures may have been installed to limit electrical surges from entering

your business, absolute protection from lightning is impossible.

•

If you suspect a natural gas leak, report it immediately, but use a telephone away

from the area in question. The telephone's electrical contacts could generate a tiny

spark. While unlikely, it is possible that this spark could ignite heavy concentrations

of gas.

•

Never push objects of any kind into the equipment through housing slots since they

may touch hazardous voltage points or short out parts that could result in a risk of

electric shock. Never spill liquid of any kind on the telephone. If liquid is spilled,

however, refer servicing to proper service personnel.

•

To reduce the risk of electric shock, do not disassemble this telephone. There are

no user serviceable parts. Opening or removing covers may expose you to

hazardous voltages. Incorrect reassembly can cause electric shock when the

telephone is subsequently used.

Service

•

Before cleaning, unplug the telephone from the ethernet jack and the power supply.

Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

•

Unplug the telephone from the modular wall jack. Be sure to refer servicing to

qualified service personnel when these conditions exist:

— If liquid has been spilled into the telephone.

— If the telephone has been exposed to rain or water.

— If the telephone has been dropped or the housing has been damaged.

— If you note a distinct change in the performance of the telephone.

Declaration of Conformity

To download the Declaration of Conformity (DoC) for this equipment, visit http://

www.avaya.com/support

SAVE THESE INSTRUCTIONS

When you see this warning symbol on the product, refer to

this instructions booklet for more information before

proceeding.