- ページ 4

水ポンプ Gardena 4000/2 automatic 1742のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena 4000/2 automatic 1742 14 ページ。 Rain water tank pump
Gardena 4000/2 automatic 1742 にも：取扱説明書 (9 ページ), 取扱説明書 (10 ページ), 取扱説明書 (9 ページ), 取扱説明書 (10 ページ)

ページを印刷する

1. Assembly

3. Assembly

Install / deinstall foot:

4. Initial Operation

Pumping water from

containers:

When the pump is to be used for draining for a flat container,

and is therefore placed on the ground, the foot can be

assembled so that the pump suctions less dirt. The stand is

included in the package.

Install foot:

v From below, place the foot

locks

click into place.

Deinstall foot:

v Press the two locks

The telescopic pipe

transport position. The telescopic pipe is fitted with a GARDENA

Regulator Valve. We recommend the use of a GARDENA

Standard Hose Connector: Art. No. 18215 for 13 mm (1/2") and

16 mm (5/8") and Art. No. 18216 for 19 mm (3/4") respectively,

for connecting a garden hose. With the use of 19-mm-(3/4")-

hose line, the pumping quantity is the greatest.

The length of the telescopic pipe

a manner that the pump does not touch the bottom of the con-

tainer; this way, dirt in the container is kept away from the pump.

1. Pull telescopic pipe

of the pump and screw onto the pump

connector

. Ensure that the washer

lies in the mating thread

telescopic pipe

2. Loosen threaded collars

telescopic pipe

3. Adjust telescopic pipe

of the container.

The telescopic pipe can be adjusted

between 73 – 91cm.

4. Turn threaded collars

firmly again.

5. Attach mains cable

ment clip

on the telescopic pipe

6. Hang pump with telescopic pipe

the container.

7. Insert the power plug.

ATTENTION! The pump begins operating immediately.

The shut-off valve

function of a water tap. With an open system (Micro-Drip-

System, Sprinklers), the hose may not be placed deeper

than the container as otherwise the water flows through the

pump from the container even when the pump is switched off.

on the pump until the two

and pull the foot

is placed on the side of the pump in the

should be adjusted in such

from the side

of the

to the height

until they hold

with the attach-

into

in an operating pump takes on the

from the pump.