- ページ 5

水ポンプ Gardena 4000/5 JetのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena 4000/5 Jet 16 ページ。 Garden pump
Gardena 4000/5 Jet にも：取扱説明書 (16 ページ)

ページを印刷する

5. Maintenance

Cleaning your Garden Pump:

6. Trouble Shooting

Free the

impeller:

Cleaning the pump thoroughly: 1. For art.1429/1432: Unscrew 2

4. Open all possible shut-off devices in the pressure line

(watering accessories, Water Stop, etc.).

5. Drain remaining water

pe during the suction process.

6. Set On/Off switch

7. Plug the pump into a 230 V / 50 Hz alternating current socket.

8. Set On/Off switch

9. Hold the pressure hose

pump until the pump begins to pump.

If the pump does not deliver liquid after 7 minutes, set the

On/Off switch

The specified maximum self-priming height (see 9. Technical

Data) is only achieved if the pump is filled via the filler neck until it

overflows and if the suction hose is held as high as possible while

filling and during the self-priming procedure so that no liquid can

escape from the pump via the suction hose.

The GARDENA Garden Pump is essentially maintenance-free.

The pump must be cleaned after pumping chlorinated swimming

pool water.

1. Rinse the Garden Pump with lukewarm water (max. 35 °C).

If necessary add some soft cleaning agent (e.g. washing-up

liquid).

2. Remove residuals according to the waste disposal laws

applicable in your area.

Warning ! Electric shock !

Risk of injury due to electric shock.

Disconnect Garden Pump from the mains before

trouble-shooting

An impeller blocked by dirt can be freed again.

Turn the impeller bolt

This will free the blocked impeller.

screws

, remove handle

unscrew 10 screws

remove the side components

2. Unscrew the 6 housing screws

, remove housing cover

and clean the impeller chamber.

3. Tighten the impeller bolt

using a screwdriver.

4. Loosen the impeller

5. Install the impeller

in pressure hose so that air can esca-

to position „0" position.

to position „1" position.

approx. 1 m vertically above the

to position „0" (see 6. Trouble-Shooting).

using a screwdriver.

and

using a ring spanner, remove and clean.

in the reverse order.