- ページ 4

水ポンプ Gardena 8000 SPのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena 8000 SP 10 ページ。 Dirty water pump

ページを印刷する

Notes on use

Thermal motor protector

Automatic deaerating

valve

3. Initial Operation

Hose diameter

Hose connection

of universal fitting

Hose connection

v Clear the outlet line before use.

Dry-running operation causes increased wear and is to be

avoided. Therefore, in manual operation the pump must be

immediately unplugged when water fails to flow.

Avoid running of the pump for more than 10 min. against closed

delivery side of the pump.

Take care that the pump is located where the inlet openings at

the suction base are obstructed neither completely nor partly.

Stand the pump on a brick if using in a pond.

The pump is automatically switched off on overheating by

the built-in thermal motor protector. After having cooled down,

the motor automatically switches on again (see 6. Trouble

Shooting).

The automatic deaerating valve eliminates any air pockets in

the pump. During this process, air escapes through the vent

bores

and air bubbles appear underwater. This is not a defect

of your pump, but serves to deaerate the pump.

It may take several seconds for the air to escape when the

pump is immersed for the first time.

13 mm (1/ 2 ")

15 mm (5 / 8")

19 mm (3 /4")

Cut off topmost

nipple at

The following connection kits are required for 13 mm to 19 mm

connections:

13 mm (1/ 2 "): GARDENA Pump Connection Set, Art. No. 1750

15 mm (5/ 8 "): GARDENA Tap Connector, Art. No. (2)902, and

19 mm (3 /4 "): GARDENA Pump Connection Set, Art. No. 1752

Best results in delivery capacity are achieved when using

38 mm (1 1/ 2 ") hoses.

25 mm (1")

Do not cut off

any nipples.

Standard Hose Connector, Art. No. (2)916

38 mm (1 1/2 ")

Cut off top two

nipples at