- ページ 3

水ポンプ Gardena FSP 15000 7870のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena FSP 15000 7870 6 ページ。 Submersible pump for pond filter or stream

GARDENA

Submersible Pump for Pond Filter or Stream

FSP 5500 / FSP 10000 / FSP 15000

Welcome to GARDENA aquamotion ...

Please read these operating instructions carefully and observe

the notes given.

Use the instructions to familiarise yourself with the equipment,

the operating controls, their correct use, and the notes on safety.

For safety reasons, children under 16 as well as persons not

familiar with these operating instructions should not use this pump.

Keep these operating instructions in a safe place.

The Applications Range of Your Pump

Intended purpose

GARDENA Submersible Pumps for Pond Filter or Stream have

been designed for private use. They are not designed for operating

watering tools and systems. The pumps may be used indoors as

well as outdoors.

Attention

GARDENA Submersible Pumps for Pond Filter or Stream

have not been designed for constant use in the industrial sector.

Corrosive, easily combustible, aggressive or explosive sub-

stances (e.g. petrol, petroleum, nitro thinner) as well as salt-

water or food / drinking water must not be pumped.

For Your Safety

Operating the Pump

The pump should be operated via a residual current device

with a residual current rating of ≤ 30 mA (DIN VDE 0100 -702

and 0100 -738). The pump must be placed on solid, even

ground. Please ask your electrician for his advice.

Mains power cables

Mains power cables should not have a smaller cross-section

than a rubber sheathed cable of the designation H07 RNF.

Extension cables must meet the requirements of DIN VDE 0620.

For Austria

In Austria power cables should correspond to ÖVE-EM 42,

T 2 (2000) /1979 § 22 according to § 2022.1. According to this

standard pumps used in swimming pools and ponds should

only be operated via an isolating transformer. Please contact

your electrician.

For Switzerland

In Switzerland mobile appliances which are used outdoors,

must be connected via a residual-current device.

Visual check

Before operating the pump, look to see if there is any damage

of the pump (esp. regarding power cable and plug). A damaged

pump must not be used. In case of damage, please have the