- ページ 8
トリマー Gardena ComfortCut 450のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena ComfortCut 450 14 ページ。 Turbotrimmer
ページを印刷する
S
U
7. Troubleshooting
RISK OF INJURY !
Pulling the filament out
of the filament cassette :
S
U
S
T
U
5. Remove any dirt.
6. Pull approximately 15 cm of the filaments
filament cassette
7. First thread the filament
then around the guide pin
W
T
8. Insert the filament cassette
V
holder
X
9. Fit the cassette cover
so that you hear both locking clips
When fitting the cassette cover,
placed around the guide pin
V
v If the cassette cover
filament cassette
is completely in the filament cassette holder
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer
before troubleshooting.
If a filament is drawn into the filament cassette you can pull it
out again as described below.
1. Unplug the mains plug.
2. Remove the filament cassette
6. Maintenance "Replacing the filament cassette".
3. Press together the plastic ring
between your thumb and forefinger.
4. Draw the plastic ring
cassette (use a screwdriver if necessary).
You can now access the filament that was drawn into the
filament cassette.
5. Unwind the filament
through the eye of the plastic ring
the filament beforehand using a screwdriver.
6. Pull the plastic ring
7. Reinstall the filament cassette as described under
6. Maintenance "Replacing the filament cassette".
S
through the hole in the plastic ring
T
through the metal sleeve
W
.
S
into the filament cassette
.
Q
on the filament cassette holder
Q
W
and must not be trapped.
Q
cannot be touched down, turn the
S
to and fro, until the filament cassette
S
U
U
over the side part of the filament
T
approximately 15 cm and thread it
U
back over the filament cassette
T
out of the new
U
X
R
click into place.
T
the filament
must be
V
.
as described under
on the filament cassette
U
. If necessary, loosen
S
.
and
V
S
S
.
17