- ページ 6

トリマー Gardena powerCut 2404のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena powerCut 2404 12 ページ。 Turbotrimmer
Gardena powerCut 2404 にも：取扱説明書 (8 ページ)

ページを印刷する

5. Trouble-Shooting

Risk of injury !

Pulling the filament

out of the filament cassette :

Fault

The Turbotrimmer

no longer cuts.

If you have any other problems please contact the GARDENA Customer Service.

6. Storage

Overwintering :

Risk of injury from the cutting filament !

V Always unplug the mains plug of the Turbotrimmer be-

fore troubleshooting.

If a filament is drawn into the filament cassette you can pull it out

again as described below.

1. Unplug the mains plug.

2. Remove the filament cassette as described under 4. Mainte-

nance "Replacing the filament cassette" .

3. Press together the plastic ring

between your thumb and forefinger.

4. Draw the plastic ring

the side part of the filament cassette

if necessary). You can now access the filament that was drawn

into the filament cassette.

5. Unwind the filament

it through the eye of the plastic ring

cessary, loosen the filament beforehand

using a screwdriver. The filament

may stand out max. 2 cm over the knife

6. Pull the plastic ring

filament cassette

7. Reinstall the filament cassette as described

under 4. Mainte-nance "Replacing the

filament cassette".

Only GARDENA Service Centres and authorised specialist

GARDENA dealers may carry out repairs.

Possible cause

Filament worn or too short.

Filament cassette empty.

Filament drawn into the

cassette or stuck together.

The Turbotrimmer must be stored out of the reach of children.

v Store your Turbotrimmer in a dry place where it is protected

from frost.

Recommended storage :

We recommend that you hang your Turbotrimmer from the cable

lock. Hanging storage helps avoid unnecessary stress on the

cutting head.

on the filament cassette

with the thumb of the other hand over

approximately 10 cm and thread

. If ne-

back over the

Remedy

v Lengthen the filament –

see 3. Operation "Filament

feed (Tip mechanism for

automatic filament feed )".

v Replace the filament cassette

– see 4. Maintenance

"Replacing the filament

cassette" ).

v Pull the filament out of the

filament cassette (see above).

(use a screwdriver