- ページ 6
電子レンジ KitchenAid 30” Built-in Microwave HoodのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid 30” Built-in Microwave Hood 8 ページ。
ページを印刷する-
upper ablnel tmnplrle
c--------7
a
L------J
o-
00
r------l
2
I
L------l
OQOOOOQOOOOO
0 00000000000
0
wall lempkla
5.
Measure the bottom 01 the upper-
cabinet frame. Trim the edges 'A".
'B", and 'c" on the upper-cabinet
rrrglate so that the template will f-t on the
otlom of the upper cabinet. If upper cabinet has
recessed frame, trim template so that it ffis
rside the recessed area. Align the center tine of
le uppercabinet template with the center line of
18 wall template; then securely tape or tack the
pper-cabinet template in place.
Eik?cWtcal Shock Hazard
Take special care when drllllng holes
Into the well. Electrkal wires may be
concealed behlnd the wall covering and
contact with them could result In
electrical shock.
Is.i
Drill a l/2' hole tor the mounting
rods at points 'J" and 'K" on the
wall template.
[6.1
Find the points on the wall template
labeled 'D", 'E". 'F". and 'G". Drill a
306" diameter hole at the points that
are over a wall stud and a 34' cfrarneter hole at
the points that are over drywall.
3
7.
Using a thin nail to probe the wall,
tind and clearly mark the two
template points closest to the center
El
Drill a 3/6" hole at points 'L" and 'M"
w
on the uppercabinet template.
Place a washer over each l/4" x 2"
of the well stud(s) located within the merked 'H"
on the wall template. Drill a 3/16"hok into
the wall stud(s) al the two stud marks.
bolt. Then insert a bolt down through each hole
in the upper cabinet bottom. DO NOT TIGHTEN
BOLTS AT THIS TIME.