- ページ 5

電動工具 Makita UT1305のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita UT1305 8 ページ。 Mixer
Makita UT1305 にも：パンフレット (2 ページ), 取扱説明書 (16 ページ), 取扱説明書 (13 ページ), 技術情報 (7 ページ), 取扱説明書 (20 ページ)

ページを印刷する

007095

In case of mixing blade 150 (accessory), screw it directly

on the top of shaft as it is threaded.

OPERATION

Mixing

CAUTION:

Do not use to mix flammable material such as paint

•

with thinner used as solvent. Failure to do so may

cause injury.

Mixing with the mixing blade floating out of the

•

mixing material may cause the material to splash

about.

Hold the rear handle of the tool with one hand and

the grip with the other hand

mixing blade under material fully and turn on the

tool after making sure work site safety.

Move the mixing blade up and down during the

mixing operation so that whole part of material can

be mixed.

When finishing mixing, turn off the tool, make sure

that the mixing blade has come to a complete stop,

and then pull it out of the vessel.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may

result.

1. Mixing blade

2. Shaft

3. Hex bolt

firmly, place the

Replacing filter

007098

Replace the filter regularly as the cooling efficiency of the

tool is reduced due to built-up dust or particles in the

filter.

Insert the slotted bit screwdriver and the like between the

tool and the cover as shown in the figure. Lift it up just like

using a shovel and remove the cover.

Replace the filter in the cover with a new one.

Reinstall the cover on the tool.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps.

007099

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized Service Centers, always

using Makita replacement parts.

1. Filter

2. Cover

3. Screwdriver

1. Limit mark

1. Screwdriver

2. Brush holder

cap