- ページ 3

芝生とガーデン用品 Gardena 1197のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena 1197 12 ページ。 Water distributor automatic
Gardena 1197 にも：取扱説明書 (12 ページ), 取扱説明書 (12 ページ)

ページを印刷する

2. Safety instructions

The Water Distributor automatic may be

positioned at a maximum of 1.5 m lower than

the highest connected accessory.

The minimum water pressure for secure switch-

ing operation during irrigation is 1 bar.

If too many devices are connected to one line,

the pressure may fall below 1 bar and will be

insufficient for proper operation. To increase

water pressure, we recommend the GARDENA

Tap Connector Art. 2801 / 2817 with ³⁄₄ " hoses

on the inlet side.

Due to the switch mechanism of the Water

Distributor, there may be drop formation during

further switching at the outlets.

Please note : on completed irrigation, the

higher-lying connecting device empties over

the lowest-placed device.

For water containing sand, a pre-filter must be

used.

3. Assembly

Assemble mounting plate :

4. Initial Operation

Connect Water Distributor :

5 4 3

With the mounting plate

mounted on the ground or on a wall (inlet on top).

1. Using the mounting plate

4 holes.

2. Screw the mounting plate tight with 4 screws

Lock Water Distributor :

v From above, move the Water Distributor on the mounting

plate

until it locks into place.

Unlock the Water Distributor :

v Press the release button

wards.

Inlet side :

1. Remove the rubber seal

replace with the filter

2. Screw the Tap Connector

side

and connect with a hose to the Water Computer or

water tap.

The Water Distributor should not be connected

to Pressure Tank Units as these present too

large pressure fluctuations.

Functioning is only guaranteed with Original

GARDENA accessories.

The individual outlets can only be operated

one after the other.

For secure switching function of the Water

Distributor, the minimum water discharge

quantity is 20 l / h. E.g. for control of the

Micro-Drip System, a minimum of 10 two-

litre Drip Heads is required.

The Micro-Drip Master Unit may not be installed

on the inlet side of the Water Distributor.

Danger !

Small parts could be swallowed during

assembly and there is a risk of suffocation

from the polybag. Keep infants away during

assembly.

, the Water Distributor can be

, mark the drill holes and drill the

and pull the Water Distributor up-

from the Tap Connector

onto the connection on the inlet

(not included).

and