- ページ 4

電話 Avaya 4600 SeriesのPDF 接続をオンラインで閲覧またはダウンロードできます。Avaya 4600 Series 14 ページ。 Infrared dialing
Avaya 4600 Series にも：設置および安全に関する指示 (11 ページ), 安全上のご注意 (11 ページ), 製品情報 (2 ページ), マニュアル (4 ページ)

ページを印刷する

2. Equipment and Software Validated

The following equipment and software were used for the sample configuration provided:

Equipment

Avaya 4602 IP Telephone

Avaya 4602SW IP Telephone

Avaya 4610SW IP Telephone

Avaya 4620 IP Telephone with EU24 Button Expansion Module

Avaya 4620SW IP Telephone with EU24 Button Expansion Module

Avaya 4630SW IP Screenphone

Avaya 4606 IP Telephone (Gen-2)

Avaya 4612 IP Telephone (Gen-1, Gen-2)

Avaya 4624 IP Telephone (Gen-1)

Avaya 4624 IP Telephone (Gen-2)

Avaya AP 3 Access Point (Version 2)

Avaya AP 5 Access Point

Avaya 30A Ethernet Switch Base

3Com SuperStack 3 Switch 4400-PWR

3. Configure the 3Com SuperStack 3 Switch 4400-PWR

This section describes the configuration steps to control and monitor inline power status. Either

the command line interface (CLI) or the web-based management interface can be used to

accomplish these tasks. These Application Notes demonstrate the configurations using the web-

based interface. By default, the switch tries to obtain an IP address from a DHCP or BOOTP

server on the network. If neither server is found, the switch configures itself with its default IP

address 169.254.100.100. In these Application Notes, there is no DHCP server available in the

configuration.

Steps

Access the switch using a web browser

• Configure a laptop or PC with an IP address in the 169.254.100.0/24 subnet. Launch a

web browser and point to http://169.254.100.100.

• Log in using the appropriate credentials as shown in Figure 3.

SZ; Reviewed:

WCH 3/19/2004

Figure 2: Avaya 30A Switch Base Connections

Table 1: Equipment and Software Validated

Solution & Interoperability Test Lab Application Notes

Description

Software

1.7

2.0

1.8

1.73

1.8

2.1.2(412)

2.1.1(375)

V.3.12

4 of 14

3com-PoE-Config.doc