- ページ 7

芝生とガーデン用品 Gardena 4068のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gardena 4068 14 ページ。 Electric aerator
Gardena 4068 にも：取扱説明書 (9 ページ), 取扱説明書 (15 ページ), 取扱説明書 (9 ページ), 取扱説明書 (14 ページ), 取扱説明書 (13 ページ), 取扱説明書 (13 ページ), 取扱説明書 (15 ページ), 取扱説明書 (10 ページ)

6. Maintenance

Cleaning Aerator :

Adjusting for wear :

Blockage Protection : If the aerator cylinder is blocked, e.g.

by a foreign body, immediately release the starting lever. If the

blockage lasts longer than 10 seconds and the starting lever

has not been released, blockage protection is activated. In this

case immediately release the starting lever.

The Aerator can be switched on again after cooling down for

approx. 1 minute.

DANGER ! The aerator cylinder can cause injuries !

V Prior to maintenance, unplug from the mains and

wait until the Aerator drum has stopped.

V Wear working gloves for performing maintenance.

The Aerator should be cleaned after each time it is used.

Risk of injury and physical damage !

V Do not clean Aerator under running water

(particularly under high pressure).

V Do not use hard or pointed objects for cleaning

the Aerator.

v Remove grass and deposits from wheels, aerator cylinder

and housing.

The Aerator is subject to wear in use due to the way in which it

works. The more intensively the Aerator is used, the greater the

wear on the knives.

Hard or very dry ground accelerates wear as does excessive use

of the Aerator.

If the results of your work with the Aerator become increasingly

worse due to knife wear, the aerator cylinder can be adjusted

twice.

The aerator cylinder has 4 adjustment positions :

• Transport position

• Aerating position 1 :

• Aerating position 2 :

First adjustment position after knife wear (aerator cylinder

lowered by 3 mm).

• Setting 3 :

Second adjustment position after knife wear (aerator cylinder

lowered by a further 3 mm)

Push wear compensation lever

and move to the position required.

Note : Wear adjustment is not used for height adjustment.

Adjustment of the aerator cylinder without visible wear can

cause damage to the aerator cylinder or overload the motor.

gently away from the housing