- ページ 2

電話 Avaya 8405DのPDF 機能マニュアルをオンラインで閲覧またはダウンロードできます。Avaya 8405D 4 ページ。 Using the new abbreviated dialing program feature

ページを印刷する

1. Programming Abbreviated Dialing Button on Softkeys

Introduction

Beginning with Release 6.3 of the DEFINITY

software, the following enhancements have been made to the Abbreviated Dialing

(AD) Program feature:

•

Messages appear on the display to step you through the programming

procedure. When you program a softkey, you can also program a label of

up to five characters that will appear on the display directly above it.

•

To be programmable for abbreviated dialing, a button, whether it is a

softkey or a hardkey (feature button), must be administered for the

Abbreviated Dialing feature. You can use the Button View feature to find

the Abbreviated Dialing buttons on your set. (To do this, select BtnVu from

the softkey menu; then press the button you want to check.)

NOTE: If the speaker on your set has been deactivated, this feature will not work as

described below. See your system manager to activate your speaker.

Programming an Abbreviated Dialing button on Softkeys

(the four buttons immediately below the display

NOTE: If you make a mistake while programming, you CANNOT move back a

space to erase it. Instead, save whatever you have entered by pressing the "#" key

and start over.

1. Enter Programming mode. (To do this, press the button labeled Prog, if

your set has one, or select Prog from the softkey menu by pressing the

Menu button, then the Next or Prev button, if necessary, until you see Prog

on the display. Then press the softkey below Prog.)

Your telephone will go off-hook, and the light next to

will see the message, Press button to program on the display .

NOTE: If you do not see this message once you have entered

Programming mode, your telephone is probably NOT connected to a

Release 6.3 switch. For help, contact your system manager.

2. Select the softkey/feature button you want to program. (To do this, press the

Menu button again, then press Next or Prev, if necessary, until you see the

label of the softkey you want on the display; then press the softkey below

that label.)

You will see the message, Change number? Yes=1 No=2 on the display.

3. If you want to enter a new number or change an existing number, press the

"1" key on the dial pad and continue with Step 3A. If you do not want to

change the number, press the "2" key and skip to step 3B.

CFrwd

CPark

These are the four softkeys

ECS and/or PROLOGIX™

Prog

AD8

)

will go on. You

Spkr