- ページ 4

電子レンジ KitchenAid KHHC2090SBT2のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid KHHC2090SBT2 12 ページ。 Microwave hood combination

INSTALLATION
INSTRUCTIONS
Depending on your model, the mounting plate may be in the foam
packaging, or it may be attached to the back of the microwave
oven.
NOTE: To avoid possible damage to the work surface, cover the
work surface.
1. Remove any remaining contents from the microwave oven
cavity.
2. If the mounting plate is attached to the back of the microwave
oven, remove it and set it aside.
3. Tape the microwave oven door closed so that door does not
swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip or
use the door or door handle while the microwave oven is being
handled.
2. With vent deflector oriented as shown (wide side down), slide
it back and under the back edge of the vent opening.
A
B
<Y
The microwave oven issetforrecirculation
installation.
Forwallor
roofventing, c hanges must be made totheventing system.See
"Venting Design Specifications"
section.
NO"I'I=: Skip this sectionif you areusingrecirculation
installation.
Keep thedamper assembly incase theventing method is
changed, orthemicrowave oven isreinstalled
inanotherlocation
where wallor roofventing may be used.
To preparethe microwave oven forwallorroofventing, t hevent
deflector (L-shapedmetal bar) must be installed,
and the
appropriate damper vent opening must be uncovered.
To Install Vent Deflector:
1. Gently pull the rings and lift vent screen from the top of the
microwave oven.
3.
A. Vent opening
B. Vent deflector
When the vent deflector is as far back as it can easily slide, flip
it so that the wide side is to the back of the microwave oven,
and the narrow side (with holes) is down. The vent deflector
holes should align with mounting holes in the vent opening, as
shown in inset.
/
B
C
A. Top of microwave
oven
B. Vent screen
C. Rings
4.
A. Vent opening
B. Vent deflector
Secure vent deflector with 2 mounting screws (1 on each end).
A
B
A. Mounting screw
B. Vent deflector
5. Replace vent screen.
4