- ページ 7

ドリル Makita 197413-5のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 197413-5 13 ページ。 Cordless cutter
Makita 197413-5 にも：取扱説明書 (13 ページ), 取扱説明書 (12 ページ)

ページを印刷する

Reversing switch action

► 1 . Reversing switch lever

CAUTION:

Always check the direction of

rotation before operation.

CAUTION:

Use the reversing switch only after

the tool comes to a complete stop. Changing the direc-

tion of rotation before the tool stops may damage the tool.

CAUTION:

When not operating the tool, always

set the reversing switch lever to the neutral position.

This tool has a reversing switch to change the direction

of rotation. Depress the reversing switch lever from the

A side for clockwise rotation or from the B side for coun-

terclockwise rotation.

When the reversing switch lever is in the neutral posi-

tion, the switch trigger cannot be pulled.

ASSEMBLY

CAUTION:

Always be sure that the tool is

switched off and the battery cartridge is removed

before carrying out any work on the tool.

Installing or removing driver bit/

socket bit

Optional accessory

Use only driver bit/socket bit that has inserting portion

shown in the figure. Do not use any other driver bit/

socket bit.

For tool with shallow driver bit hole

A=12mm

B=9mm

For tool with deep driver bit hole

A=17mm

B=14mm

A=12mm

B=9mm

To install the driver bit, pull the sleeve in the direc-

tion of the arrow and insert the driver bit into the

sleeve as far as it will go.

Then release the sleeve to secure the driver bit.

► 1 . Driver bit 2. Sleeve

To install the driver bit, pull the sleeve in the direc-

tion of the arrow and insert the bit-piece and driver

bit into the sleeve as far as it will go. The bit-piece

should be inserted into the sleeve with its pointed

end facing in. Then release the sleeve to secure

the driver bit.

► 1 . Driver bit 2. Bit-piece 3. Sleeve

To remove the driver bit, pull the sleeve in the direction

of the arrow and pull the driver bit out.

7 ENGLISH

Use only these type of driver

bit. Follow the procedure

1. (Note) Bit-piece is not

necessary.

To install these types of driver

bits, follow the procedure 1.

To install these types of driver

bits, follow the procedure 2.

(Note) Bit-piece is necessary

for installing the bit.