- ページ 4

ドリル Makita 60921のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 60921 17 ページ。 10 mm (3/8") cordless driver drill equipped with electric brake

IMPORTANT
Length of Cord (Feet)
AWG Size of Cord
SAFETY
25
50
100
150
18
18
18
16
IN STRU CTI 0 N S
1.
2 .
3.
4.
5 .
6.
7.
8.
SAVE THESE INSTRUCTIONS
- This manual
contains important safety and operating instructions for battery charger.
Before using battery charger, read all instructions and cautionary markings
on (1) battery charger, ( 2 ) battery, and ( 3 ) product using battery.
CAUTION - To reduce risk of injury, charge only MAKITA Battery 7000,
9000 or 9100. Other types of batteries may burst causing personal injury
and damage.
Do not expose charger to rain or snow.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury to persons.
To reduce risk of damage to electric plug and cord, pull by plug rather than
cord when disconnecting charger.
Make sure cord is located so that it will not be stepped on, tripped over,
or otherwise subjected t o damage or stress.
An extension cord should not be used unless absolutely necessary. U s e of
improper extension cord could result in a risk of fire and electric shock. I f
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape
b. That extension cord
is
properly wired and in good electrical condition; and
c. That wire size is at least a s large a s the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
a s those of plug on charger;
9. Do not operate charger with damaged cord
or
plug - replace them imme-
diately.
I O . Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way; take it t o a qualified serviceman.
11. Do not disassemble charger or battery cartridge; take it to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attemp-
ting any maintenance or cleaning. Turning off controls will not reduce this
risk.
4