- ページ 7

ドリル Makita 6092DのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6092D 17 ページ。 10 mm (3/8") cordless driver drill equipped with electric brake

When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period,

may not accept

full charge. This is

a normal

condition and does

not indicate a problem. You can recharge the battery cartridge fully after discharging

almost completely a couple of times.

If you wish to charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.

Installing or removing drill

bit

or driver

bit

CAUTION :

Always be sure that the tool is switched off and the battery cartridge is removed before

installing o r removing the bit.

To install the bit, place

in the chuck as

far as it will go. Tighten t h e chuck by hand.

Place the chuck key in each of the three

holes and tighten clockwise. Be sure to

tighten all three chuck holes evenly.

To remove t h e bit, turn the chuck key

counterclockwise in just one hole, then

loosen t h e chuck by hand.

After use, return the chuck key to the

storage cavity on the

tool.

Holding tool

H'old the tool as shown in the figure.

When drilling a large diameter hole, hold

the tool firmly with both hands.

Tighty

Chuck key