- ページ 4

ドリル Makita 6093DWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6093DW 17 ページ。 Equipped with electric brake 10 mm (3/8") with fast charger
Makita 6093DW にも: 取扱説明書 (16 ページ)

Makita 6093DW 取扱説明書
IMPORTANT SAFETY
1 .
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings
o n (1) battery charger, (2) battery, and (3) product using battery.
3. CAUTION
-
To reduce risk of injury, charge only MAKITA Battery 7000,
9000 or 9100. Other types of batteries may burst causing personal injury
and damage.
4. Do not expose charger to rain
or snow.
5. Use of an attachment not recommended
or
sold by the battery charger
manufacturer may result in a risk of fire, electric shock,
or
injury to persons.
6. To reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7. Make sure cord
is located so that
it
will not be stepped on, tripped over,
or
otherwise subjected t o damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a . That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and in good electrical condition; and
c.
That wire size is at least a s large a s the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
as those of plug on charger;
Length of Cord (Feet)
I
25
I
50
I
100
I
150
AWG Size of Cord
I
18
I
1 8
I
18
I
16
I
9. Do not operate charger with damaged cord or plug
-
replace them im-
mediately.
IO. Do not operate charger if it has received a sharp blow, been dropped,
or
otherwise damaged in any way; take it to a qualified serviceman.
1 1 . Do not disassemble charger
or
battery cartridge; take it to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
4