- ページ 9

ドリル Makita 6222DWEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6222DWE 16 ページ。 Cordless driver drill equipped with electric brake

CAUTION:

Always withdraw the tool from the workpiece before resuming operation. If the tool can-

not be withdrawn, hold the tool firmly when turning on the tool,

overcome a strong

reaction.

Adjusting the fastening torque

The fastening torque can be adjusted in six

stages by turning the adjusting ring so that

the pointer on the adjusting ring points to a

number on the tool body. The fastening

torque is minimum when the pointer points

to the number 1 and maximum when it

points to the .\-marking. The clutch will slip

at varying torque levels when the pointer is

set at the numbers

to 5. The clutch is

designed not to slip at the

.--

marking.

Before actual operation, drive

trial screw

into your material or a piece of duplicate

material to determine which torque level is required for a particular application.

NOTE:

The adjusting ring cannot be locked with the pointer positioned half-way between the

Pointer Drill marking

numbers.

Screwdriving operation

Place the point of the driver bit in the screw

head and apply pressure to the tool. Start

the tool slowly and then increase the speed

gradually. Release the trigger as soon as

the clutch cuts in.

\\\

NOTE:

*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or

bit may be damaged

*When driving wood screws, predrill pilot

holes to make driving easier and to pre-

vent splitting of the workpiece. See the

chart.