- ページ 6

ドリル Makita 6227DのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6227D 12 ページ。
Makita 6227D にも：取扱説明書 (8 ページ)

ページを印刷する

1. Low speed

2. High speed

3. Speed change lever

1. Adjusting ring

2. Drill marking

3. Pointer

4. Graduations

ASSEMBLY

1. Sleeve

2. Ring

3. Tighten

Speed change

002096

To change the speed, first switch off the tool and then slide the speed change

lever to the "II" side for high speed or "I" side for low speed. Be sure that the

speed change lever is set to the correct position before operation. Use the

right speed for your job.

CAUTION:

•

Always set the speed change lever fully to the correct position. If you

operate the tool with the speed change lever positioned halfway between

the "I" side and "II" side, the tool may be damaged.

•

Do not use the speed change lever while the tool is running. The tool

may be damaged.

Adjusting the fastening torque

002104

The fastening torque can be adjusted in 17 steps by turning the adjusting ring

so that its graduations are aligned with the pointer on the tool body. The fas-

tening torque is minimum when the number 1 is aligned with the pointer, and

maximum when the

The clutch will slip at various torque levels when set at the number 1 to 16. The

clutch is designed not to slip at the

Before actual operation, drive a trial screw into your material or a piece of

duplicate material to determine which torque level is required for a particular

application.

NOTE:

•

The adjusting ring does not lock when the pointer is positioned only

halfway between the graduations.

CAUTION:

•

Always be sure that the tool is switched off and the battery cartridge is

removed before carrying out any work on the tool.

Installing or removing driver bit or drill bit

002118

Hold the ring and turn the sleeve counterclockwise to open the chuck jaws.

Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the

sleeve clockwise to tighten the chuck.

To remove the bit, hold the ring and turn the sleeve counterclockwise.

marking is aligned with the pointer.

marking.