- ページ 12

ドリル Makita 6227DWEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6227DWE 19 ページ。 9.6 v i2 v 14.4 v
Makita 6227DWE にも：取扱説明書 (19 ページ), 取扱説明書 (19 ページ), 取扱説明書 (19 ページ)

ページを印刷する

OPERATION

*When driving wood screws, predrill pilot

holes to make driving easier and to pre-

chart.

N $ 2 A : :

; : ;

; f

3.1

11iE"I

3.5 19/64")

3.8

15/32")

4.5

1 1 1 " )

4.8 13/16')

5 . 1 1 1 W ' I

5 . 5 17/32")

5 . 8 17/32?

6 . 1 115/64"1

vent splitting of the workpiece. See the

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure to the tool.

Start the tool slowly and then increase the

speed gradually. Release the trigger as

soon as the clutch cuts in.

- _ _

Recommended

size

pilot hole

lmml

2.0

2 . 2 15/64"

3/32")

2.3

2.5 13/32"

3/32")

2.5

2 . 8 13/32"

7/64")

2.9

3.2 17/64"

1/8"1

3 . 1

3 . 4 11/8"

9W'l

3.3

3 . 6 11/8"

9/64")

3.7

3.9 19/4"

5/32'?

4.0-4.2 15/32"-11164")

4.2-4.4(11/64"-11/64"1

NOTE:

*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or

bit may be damaged.

*If the tool is operated continuously until the battery cartridge has discharged, allow the

tool to rest for

minutes before proceeding with a fresh battery.

Drilling operation

First, turn the adjusting ring so that the pointer on the tool body points to the

marking.

Then proceed as follows.

*Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

prevent the bit from slipping when starting a hole, make an indentation with

center-

punch and hammer at the point to be drilled. Place the point of the bit in the indentation

and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

*Drilling in metal