- ページ 8
ドリル Makita 6236DWAEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6236DWAE 20 ページ。 Cordless driver drill equipped with electric brake
Makita 6236DWAE にも： 取扱説明書 (20 ページ)
ページを印刷する
CAUTION:
*The high capacity battery charger Model DC1411 is for charging Makita battery cartridge.
Never use it for other purposes or for other manufacturer's batteries.
*When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time, it may not accept a full charge. This is a normal condition and
does not indicate a problem. You can recharge the battery cartridge fully after discharging
it
completely and recharging
a
couple of times.
*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has
been left in a location exposed to direct sunlight or heat for a long time, the charging light
may flash in red color. If this occurs, wait for a while. Charging will begin
after
the battery
cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge
from the high capacity battery charger.
*If the charging light flashes alternately in green and red color, a problem exists and charg-
ing is not possible. The terminals on the charger or battery cartridge
are
clogged with
dust or the battery cartridge is worn out or damaged.
ASSEMBLY
Installing or removing driver bit or drill bit
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go. Hold
the ring firmly and turn the sleeve clock-
wise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
When not using the driver bit, keep it in the
bit holders. Bits 45 mm (1-3/4") long can be
kept there.
Bit
8