- ページ 7
ドリル Makita 6236DWBEのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6236DWBE 20 ページ。 Cordless driver drill equipped with electric brake
Makita 6236DWBE にも： 取扱説明書 (20 ページ)
ページを印刷する
Installing or removing battery cartridge
*Always switch off the tool before insertion
or removal of the battery cartridge.
*To remove the battery cartridge, withdraw
it from the tool while pressing the buttons
on both sides of the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into place.
Always insert
it
all the way until it locks in
place with a little click. If not, it may acci-
dentally fall out of the tool, causing injury
to you or someone around you.
easily, it is not being inserted correctly.
*Do not use force when inserting the battery cartridge. If the cartridge does not slide in
Charging
*Your new battery cartridge is not charged.
You will need to charge it before use. Use
the high capacity battery charger Model
DC1411 to charge the battery cartridge.
*Plug the high capacity battery charger into
the proper A.C. voltage source. The charg-
ing light will flash in green color.
*Insert the battery cartridge so that the plus
and minus terminals on the battery car-
tridge are on the same sides as their
respective markings on the high capacity
battery charger. Insert the cartridge fully into the port so that it rests on the charger port
floor.
*When the battery cartridge is inserted, the charging light color will change from green to
red and charging will begin. The charging light will remain lit steadily during charging.
*When the charging light color changes from red to green, the charging cycle is complete.
The charging time is approximately one hour.
*If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last
approximately 24 hours.
*After charging, unplug the charger from the power source.