- ページ 2

Rfidシステム Alien ALR-F800のPDF Wi-Fiセットアップをオンラインで閲覧またはダウンロードできます。Alien ALR-F800 6 ページ。

General Setup Procedure

The general procedure to enable Wi-Fi functionality consists of the following steps:

1. install the ALR-F800 firmware v17.07.17 or later

2. plug in the compatible Wi-Fi USB adapter (from the list of supported devices below)

3. add a new Wi-Fi network configuration that includes at least the network SSID and

the password parameters

service wifi add "SSID"

service wifi set net 0 psk "PASSWORD"

NOTES

 in most cases make sure to use DOUBLE QUOTES around the SSID and the

PASSWORD values (use no quotes only when using hexadecimal values)

 several networks could be added to the reader Wi-Fi configuration, each with

its own set of parameters. Use a 0-based network ID/index when configuring

the specific network

4. start wifi service to connect to the WiFi network added above:

service wifi start

5. enable wifi service to automatically start WiFi interface on boot:

service wifi enable

ALR-F800 Wi-Fi Setup

APN-1046