- ページ 3

おもちゃ Alien Aircraft Super Dragon AG-501のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Alien Aircraft Super Dragon AG-501 7 ページ。 Glow conversion

Building Instructions:

Building the Glow powered version of the Super Dragon is almost identical to building the electric powered version.

The main difference between the models is the motor pylon. As such, you should follow the regular instruction man-

ual to build the model up to step 125 with the following exceptions:

Step 21...You do not need to glue Velcro to the battery tray. In the glow version you will wrap the radio battery with

foam rubber and place it in the nose of the model. The foam rubber will wedge it in place and it should not move

around.

Step 54...The holes for the aileron servo wires in the bottom of the center section should be smaller and farther for-

ward than shown in the photo to make room to mount the throttle servo on the bottom of the wing.

Step 60...You do not need to remove the mounting hole for the arming switch. It is not used in the glow powered

version.

Step 61 - 64...Do not cut out the hatch. It is not needed as you will not be replacing the battery between flights.

Steps 125 - 129...Do not use these. The pylon is built using the following steps:

Building the Motor Pylon:

1... Securely glue the two GP-01's, GP-02's and

GP-05's together as shown. The is a lot of

force and vibration on the pylon so it is best to

use Epoxy to assemble all of the plywood parts

on the pylon.

2...Press the four 6-32 blind nuts into the holes in the back of the fire-

wall (GP-01). Secure them with a small drop of thin C/A glue.

3...Glue the GP-3's to the sides of GP-2. They

should be 90 degrees to each other.

Page 3