- ページ 4
アクセサリー A&E Systems 971 56 Oasis-Elite SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。A&E Systems 971 56 Oasis-Elite Series 7 ページ。 Automatic and manual rv door awning system
ページを印刷するImportant:
The Black and White wires extending
through the end cap are not used for this installation.
Cut wires off flush with end cap and throw away.
8 . Choose a desired location for the remote switch inside
the living quarters such as the door area. Avoid areas
where switch may be exposed to weather.
9 . Cut hole in structure where remote switch is to be
installed. Place decal on bezel and pop switch into
opening. Secure bezel with appropriate fasteners (not
sup p li ed ) .
1 0 .Route a Brown, Yellow and Green wire from the
remote switch to the control box. Install 1/4" insulated
terminals on remote switch end of wires. Use the
supplied pig tail to connect the switch to the Brown/
White, Yellow/White and Green/White wires at the
control box.
Important:
Dielectric grease must be placed
3 on all exposed pins.
11 .Run two (2) wires from the control box to the 12 VDC
supply source. It is recommended that these wires be
(Red+ and Black -) 12 gauge wires. This should be on
a separate 15 amp circuit. Connect the Red and
Black wires from the control box to the 12VDC supply
wires using butt connectors.
1 2 .To ensure proper operation, the control box must have
a minimum of 12.5 VDC at the control box during
awning operation. It may be necessary to increase the
wire size if voltage is below 12.5 VDC.
13. Auto Interlock Connection
A . Run a 16 gauge wire (installer supplied) from the
ignition Switch (+ 12 VDC when key is on) of
vehicle to the Ignition Interlock (Pink) wire of
control box.
B . Connect wires using supplied pigtail. See FIG. 7
and FIG. 7A.
D. OTHER INSTALLATION NOTES
1 . To prevent water leakage, always use silicon sealant
where each fastener enters the sidewall of the vehicle.
2 . Do not over tighten fasteners. This will cause them to
"strip out" and severly weaken their holding ability.
OPERATING INSTRUCTIONS
A.TO OPEN
1 . Oasis (Manual)
a . Place the hook of the crank into the eye of the gear
and turn gear counter-clockwise to unroll the
awning. (See FI G .4 ) .
FIG. 4
Gear
Crank
2 . Oasis/Elite ( E l e c t r i c )
a . Press and hold the remote switch in the extend
position until the awning is fully open. Release
switch to prevent awning from rolling up back-
wards. See FIG.5.
Fig. 5
b . Awning can also be opened manually by using the
crank without using the switch. See FIG. 4.
4
Remote
Switch
EXTEND
RETRACT