- ページ 12

ハンダ付けガン AlienTek T12のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AlienTek T12 16 ページ。 Smart soldering station

ALIENTEK

voltage is low as shown in Figure 5.1. The default is 19.8V, which is 6S lithium battery pack ×

3.3V. Usually, the lithium battery is basically less than 3.3V. This parameter can be adjusted

(10~26V), and user can adjust the value according to battery.

Output current: range: 0.1~1.5A (default 1A). When AC power is used and the battery is

connected, this value is the current that charges the battery.

Output Enable: Turns charging on or off.

Note: The output voltage is 25.2V, only supports 6-cell lithium battery pack charging!

6.9 Language

The system supports three languages: Simplified Chinese, English, and Traditional Chinese.

Version information: The firmware version of the current soldering station.

Factory reset: Restores most of the setup parameters to factory values, but does not include

language selection.

T100 Smart Soldering station

Fig 6.10 battery low

Fig 6.11 language

Fig 6.12 version information

Fig 6.13 factory reset

User Manual