- ページ 10

GPS Garmin 010-10755-00 - MapSource City SelectのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Garmin 010-10755-00 - MapSource City Select 15 ページ。 Software de mapeamento
Garmin 010-10755-00 - MapSource City Select にも：ユーザーマニュアル (24 ページ), オーナーズマニュアル (2 ページ), ユーザーマニュアル (30 ページ), ユーザーマニュアル (28 ページ), (ポルトガル語）ユーザーマニュアル (30 ページ)

4. Find and highlight the incorrect Programmer entry on the Device

Manager list, click on "Remove", then click 'OK' to conﬁ rm.

5. Click "Refresh", then click "Next" to begin searching for the driv-

ers. On the next screen, let Windows search by leaving the bullet

on the "Search for best driver.." option and click "Next". On the

next screen, check ONLY the "CD-ROM drive" option and click

"Next".

6. The Wizard will search for the driver and then display a window

to tell you it is ready to install. Click on "Next". You may see a

"Copying Files..." screen which tells you the ﬁ le cannot be found.

Choose Root Directory of the CD-ROM drive if not already there,

and to try copying again (example d:\). Click "OK" to continue.

7. When installation is complete a window should display that shows

the device name (Garmin USB Data Card Programmer) and states

the driver installation is ﬁ nished. Click on "Finish".

8. To make sure the USB Programmer has been successfully installed:

From the Control Panel, click on "System", then the "Device Man-

ager" tab, then click the + by "Universal serial bus controller".

You should see "Garmin USB Data Card Programmer" on the list.

Another method would be to open the MapSource program, click

the 'Save To Device' icon, then the 'USB Port' tab. You should see

"Card Programmer" listed in the "Save Maps To:" window.

If the installation is still not successful, try shutting the computer

off for 1 minute, then trying the alternate steps again. A red 'X' over

the Programmer icon in Device Manager normally indicates a defec-

tive Programmer. If the USB Programmer still will not install, please

contact Garmin Product Support for further assistance.

Installation

Installing the Device Drivers

Windows XP Users: During installation of the USB

Data Card Programmer you will see a message stating:

"The following device has not passed the Windows Logo

testing to verify its compatibility with Windows XP.

Continuing your installation of this software may

impair or destabilize the correct operation of your

system either immediately or in the future. Microsoft

strongly recommends that you stop this installation now

and contact the hardware vendor for software that has

passed Windows Logo testing."

Garmin engineers have fully tested this prod-

uct and it is compatible with Windows XP.

Press the 'Continue Anyways' button to ﬁ nish

the installation.