- ページ 39

GPS Garmin 15LのPDF 技術仕様をオンラインで閲覧またはダウンロードできます。Garmin 15L 40 ページ。 Garmin gps 15l: reference guide
Garmin 15L にも：リファレンス・マニュアル (1 ページ)

ページを印刷する

File Menu

The File Menu allows you to open, save, and print sensor configurations. The items in the File

Menu work like most Windows-based programs.

Comm Menu

The Comm (Communication) Menu allows you to set the port number, baud rate, and then

connect and disconnect from the sensor.

Disconnect: Select Disconnect to disconnect from the sensor.

Config Menu

The Config (Configuration) Menu allows

you to configure the sensor as it is

connected.

Sensor Configuration (F6): Opens the

Sensor Configuration Window, shown to

the right. Many of the fields in this window

should be left alone. Please refer to the

beginning of this manual for clarification

about some of these fields. This window

is primarily used to enter a new Latitude,

Longitude, and Altitude for the sensor.

This is especially helpful when you are

programming the sensor for use in a

particular geographic location.

Resetting the Unit (Reset Unit) performs

a reset on the unit, much like cycling the

power.

Resetting the non-volatile memory (Reset

NonVol) will clear all of the data from the

non-volatile memory.

NMEA Sentence Selections (F7):

Displays the NMEA Sentence Selections

Window. If the sentence is enabled, a

check mark appears in the box to the left

of the sentence name. Click the box to enable or disable the sentence.

Get Configuration From GPS (F8): Retrieves the current programming from the sensor. The

programming is then displayed in the Main Interface Window.

Send Configuration To GPS (F9): Sends the programming changes you have made to the

sensor.

Switch to NMEA Mode (F10): Switches the unit to NMEA 0183 Mode. The sensor must be in

NMEA 0183 Mode in order to establish a serial connection to this software (see

the

Sensor" on page 38).

Switch to Garmin Mode (F11): Switches the unit to Garmin Mode.

Setup: Opens the Comm Setup Window, shown to the left.

Select the Serial Port to which the sensor is connected from

the drop-down list.

Select Auto (the program determines the baud rate on its

own) or Manual (you then enter the baud rate) for the Baud

Rate entry.

Connect: Select Connect to connect to the sensor to

change or view the configuration.

"Connecting to