- ページ 9
トランシーバー Alinco DR-510EのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Alinco DR-510E 16 ページ。 Vhf/uhf dual band fm transceiver
Alinco DR-510E にも: 取扱説明書 (8 ページ), 仕様 (2 ページ)
6. CALL Channel Entry
(DR-510Tonly)
A. Selecl VFO mode by pressing
the VFO/M key.
B. Selecl the desired operaling
band and frequency.
C. Press the F key, and then press
the CALL W.
D. When the CALL W is pressed,
the frequency shown on the
LCD will be stored inte memory
"C".
E. Whenever CALL is pressed,
Memory "C" will come to the
dispiay.
F. To Change from CALL mode
back to VFO or Memory, press
the VFO/M key.
7. MEMORY
A lithium battery is instaiied to
retain memory in the transceiver.
Turning off the POWER switch,
disconnecting power cable, or a
power failure will not erase mem
ory. The battery should fast for
approximately 5 years.
•MIcroprocessor Initiallzatlon
When you want to erase all pro-
grammed data, or if the dispiay
should Show erroneous Informa
tion, you should reset (initialize)
the microprocessor using the foi-
lowlng procedure:
1. Press and hold the F key and
the VFO/M key at same time,
and
turn
off
the
POWER
switch. New turn the POWER
switch on again, while still
holding buttons depressed.
2. Release the buttons—Factory
Programming is now in place.
•Memory Channel
This transceiver has 14 memory
Channels (1-9, A-E). In additlon
to serving as normal memory
Channels, some serve a dual pur-
pose. The functions of the Mem
ory Channels A-D are described
below.
A. Memory Channels A and B
are used to störe the Frequen
cy iimits for the Program Scan
Function. For additionai in-
formation, see VHF or UHF
Band Scan on page 11.
B. Memory Channel C is used to
Store the CALL Channel fre
quency.
C. Memory Channel D is used to
Store the transmit frequency
used for odd offset Operation.
•Memory Channel Contents
Each Memory Channel is capable
of sloring;
Frequency
SHIFT Status (Offset)
TONE Status, (Encode, Decode,
and Frequency)
Receive Frequency for Dual band
Operation. See page 14.
•Memory Entry
1. Press the VFO/M key to select
the VFO mode.
2. Select the desired operating
frequency.
3. Activate sub audible tone if it is
required.
4. Press the F key. The "M"
indicator will flash.
- 9 -