- ページ 29
オーブン AEG BE5013001のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG BE5013001 40 ページ。 Aeg oven
AEG BE5013001 にも： ユーザーマニュアル (36 ページ)
ページを印刷する
Folding down the heating element
1.
Remove the shelf supports.
2.
Hold the heating element with the two
hands at the front
3.
Pull it forwards against the spring pres-
sure and out along the support on both
sides.
4.
The heating element folds down.
The ceiling is ready to clean.
Installing the heating element
1.
Install the heating element in opposite
sequence.
Install the heating element correctly on the two sides above the support on the inner wall
of the appliance.
2.
Install the shelf supports.
Door and glass panels
To clean the door, remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the door
1.
Open the door as far as it goes.
2.
Fully press clamping levers (A) on the
two door hinges.
3.
Close the door until the first position
(angle approximately 70°).
4.
Hold of the door with one hand on each
side and pull it away from the at an up
angle.
To install the door follow the procedure in
reverse.
The number of glass panels if different for the different models.
CAUTION!
Put the door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1.
Remove the door.
Care and cleaning
A
A
29